Eppendorf BioSpectrometer basic - Supplementary Information Manuel d'utilisateur télécharger pdf

Eppendorf BioSpectrometer® basic — Supplementary Information

Supplementary Information

— Eppendorf BioSpectrometer® basicseeon p.Fig.Tab .p.

Leaflet

Changes in the operating manual

This supplementary sheet is a supplement to the operating manual for the BioSpectrometer basic and not a

substitute. Therefore, also read the operating manual of the BioSpectrometer before using the

BioSpectrometer for the first time. The current version of the operating manual is available on the internet at

www.eppendorf.com

1.2.1 Hazard icons

2.1 Main illustration

The location of the name plate deviates from the main illustration. It is located on the bottom of the device on

the rear left.

2.3.5 Device self-check

The factory setting for the self-test interval has been adjusted to "weekly".

During the self-test, ensure that the following requirements are met:

• Observe the ambient conditions (chapter 11.2).

• Avoid temperature fluctuations (for example, caused by open windows).

• After the device has been transported from a cool to a warmer environment, condensation can form

inside the device. Wait at least three hours before connecting the device to the power supply.

• Make sure that the cuvette shaft is clean.

4.4/4.5 Connecting a printer/PC

 Only connect devices that meet the safety requirements defined in IEC 60950-1.

5.3.2 Measurement procedure and 6.4.7 print & export

Method step print & export

In the print & export method step the [Sample] softkey is active in the display.

• If you want to select sample results for export or printout, press the [Sample] softkey.

6.2.2 Routine method group

Proteins direct UV: 2 additional methods

Nucleic acids: 1 additional method

Caution, general hazard point, observe the operating manual.

Protein A 280

Evaluation using factor = 1

Absorbance values are displayed directly as a result.

Protein A 280 1 mm

Parameter Cuvette = 1 mm

For microliter cuvettes with a light path of 1 mm, e.g., Hellma

TrayCell or

microliter cuvettes of a similar design.

dsDNA 1 mm

Parameter Cuvette = 1 mm

For microliter cuvettes with a light path of 1 mm, e.g., Hellma

TrayCell or

microliter cuvettes of a similar design.

1 2 3 4

Résumé du contenu

Page 1 - Supplementary Information

Eppendorf BioSpectrometer® basic — Supplementary InformationSupplementary Information — Eppendorf BioSpectrometer® basicseeon p.Fig.Tab .p.Leafle

Page 2

Eppendorf BioSpectrometer® basic — Supplementary Information11.1 Technical data: power supply11.2 Technical data: ambient conditionsPower supply 100

Page 3 - Beilageblatt

Eppendorf BioSpectrometer® basic — Zusätzliche InformationZusätzliche InformationEntwurf — Eppendorf BioSpectrometer® basicsieheauf S.Abb.Ta b.S.B

Page 4

Your local distributor: www.eppendorf.com/worldwideEppendorf AG · 22331 Hamburg · Germany · Tel: +49 40 53801-0 · Fax: +49 40 538 01-556 · E-mail: epp

Commentaires sur ces manuels

Pas de commentaire

Eppendorf BioSpectrometer basic - Supplementary Information Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Eppendorf BioSpectrometer basic - Supplementary Information. Eppendorf BioSpectrometer basic - Supplementary Information Benutzerhandbuch Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Eppendorf BioSpectrometer basic - Supplementary Information