Eppendorf I-26R Large Stackable Incubator Shakers Manuel d'utilisateur télécharger pdf (Page 28)

I-26/26R Incubator  Shakers M1324-0050 Operating Manual

5. Verify that the platform is now secured to the subplatform and the drive.

Figure 12: Installing Platform

All platforms, once installed, will easily slide in and out of the shaker:

1. Unscrew both knobs and remove the knobs and the washers on the front of the

platform to release the platform from the subplatform.

2. Pull the platform forward to rest on the door guide strips. The two stop pins in the

door will keep the platform from falling off the subplatform.

3. Slide it back in and be sure to replace the washers and knobs before operating the

shaker again.

7.4 Electrical Connections

Before making electrical connections, verify that the power source voltage matches the

voltage on the ELECTRICAL SPECIFICATION PLATE and that the ON/OFF SWITCH is on

the

OFF position. The ELECTRICAL SPECIFICATION PLATE is located on the rear panel

of the unit near the POWER CONNECTOR.

SUBPLATFORM

PLATFORM

KNOB

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 53 54

Pas de commentaire

Eppendorf I-26R Large Stackable Incubator Shakers Manuel d'utilisateur Page 28